(Back to FAQs)

Issue: In Auto mode, the program is skipping stages.

The beginning times assigned to each time stage (t3-t5 and Endt) should occur after the beginning time of the previous time stage. If a beginning time occurs before the beginning time of a previous time stage, the controller will skip the stage.

(For example, suppose the beginning time for t2 is programmed for 11am, but the beginning time for t3 is programmed for 9am (earlier than t2). The controller will skip stage t3.)

  • Make sure that time stages t1-t5 and Endt follow a chronological order.
  • See section III of the User Guide for correct programming procedures
  •